Jeep Wrangler Forum banner
1 - 4 of 4 Posts

· Registered
19 Posts
Discussion Starter · #1 ·
Trying to finish up my project. Installing a Lokar shifter and noticed I am not able to connect the manual shift linkage to the transmission shift lever. Their is a factory electric module directly behind the lever and that is not allowing enough room for me to connect the lokar provided rod. Can I just remove this electric module? I have attached a picture, hope it works.


1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.