Jeep Wrangler Forum banner
  • Hey everyone! Enter your ride HERE to be a part of September's Ride of the Month Challenge!
1 - 5 of 5 Posts

·
Registered
Joined
·
5 Posts
Discussion Starter · #1 ·
I have an '09 JK 4D and just installed this lift kit. My last step is to re-connect the drive shaft, but it appears about 2" too short now. Any suggestions?
 

·
Registered
Joined
·
5 Posts
Discussion Starter · #5 ·
Thx. I ended up disconnecting the LH control arms, which allowed the front axle to float. Once connected, I used a ratcheting strap to pull my axles close enough to re-connect the control arms.
 
1 - 5 of 5 Posts
Top