Jeep Wrangler Forum banner
  • Hey everyone! Enter your ride HERE to be a part of January's Ride of the Month Challenge!
1 - 4 of 5 Posts

·
Registered
Joined
·
7 Posts
Discussion Starter · #1 ·
I have a 92 wrangler and im trying to switch over my amp and speakers from my old vehicle. it has an after market stereo and the "radio" spot in the fuse box is empty, although the radio still works. i was under the impression that all fuse's had two "prongs" but the spot in my fuse box only accepts a single prong..
My question being, is there a specific fuse i need to buy to put in there so that i can put my remote wire into the "radio" fuse spot, and will it be able to send the signal to my amp and correspond with my after-market radio?
 

·
Registered
Joined
·
7 Posts
Discussion Starter · #5 ·
@ izulookin,

I think you hit the nail on the head with that one because now that i think about it i tried to hook the cigerette lighter back up at one point and the power cord was missing..
Do you know anything about putting subwoofers in? If so do you know where i would hook the remote wire to? Since i was going to put it in the fuse box before does that mean it needs the power it would now be getting from the cigerette lighters power cord and i should tie it in with that?
 
1 - 4 of 5 Posts
Top