Jeep Wrangler Forum banner

1 - 7 of 7 Posts

·
Registered
Joined
·
147 Posts
Discussion Starter #1
My Teraflex CRD60 showed up Friday, got my 44 out and 60 in yesterday. The new 60 has 3 mounting hole locations for the upper control arms and two for the lower, curious what holes others have used as the directions make no mention.

Shot an email off to Teraflex but I don't expect a response until Monday or Tuesday.. was hoping to get everything done so I can call in Monday with my new driveshaft measurement.
 

·
Super Moderator
Joined
·
15,385 Posts
Sorry, it's early and my brain isn't functioning :)

We built this Jeep at a friends shop, these are the locations he recommended, but I have no other info/experience to say if they're correct. Jeep drives great and tracks true.

Upper:





Lower:

 

·
Registered
Joined
·
147 Posts
Discussion Starter #5
Sorry, it's early and my brain isn't functioning :)

We built this Jeep at a friends shop, these are the locations he recommended, but I have no other info/experience to say if they're correct. Jeep drives great and tracks true.

Upper:





Lower:


@Blue Baby Sound thank you sir, I will give those locations a try. :thumb:
 

·
Super Moderator
Joined
·
15,385 Posts
@Blue Baby Sound those locations seemed to work well for my 3.5" lift, thank you.

Who's driveshaft did you go with? We're you able to go with an off the shelf shaft or you had one custom made? Thanks.
:thumb: We did Adams 1350 rear and 1310 front.
 
1 - 7 of 7 Posts
Top