You want SET10 bearings for your Dana 44 axle, Timken would be a good choice of brand. I used an SKF seal the last time I did that job which is a good solid brand. Make sure you get bearing retainers with the new bearings.
2nd for Timken; I've never had one fail for unexpected reasons. Keep in mind that the seal goes between the axle flange and inner bearing race. You will have to be able to slide the new seal on before pressing the new race onto the axle shaft.
CL thanks for the Tips,
I have screwed up enough stuff in my life, so I always take pics, draw a pic or have a book with pics to cut down on the screw ups. Works most of the time but not fool proof.
Thanks Bryan
1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
A forum community dedicated to Jeep Wrangler owners and enthusiasts. Come join the discussion about reviews, performance, trail riding, gear, suspension, tires, classifieds, troubleshooting, maintenance, for all JL, JT, JK, TJ, YJ, and CJ models!