Jeep Wrangler Forum banner

1 - 4 of 4 Posts

·
Registered
Joined
·
308 Posts
Discussion Starter #1
I am installing a Pioneer HU as a replacement on my 2010 JKU. I am also looking for a backup camera. I have been told by Idatalink that the Maestro does not support the manual transmission back up switch. Does this have to go directly through the HU. Just wondering how that camera comes on in reverse.
 

·
Registered
Joined
·
4,684 Posts
I installed a Pioneer 4200NEX and ran a wire from the reverse light up to the HU.
 

·
Registered
Joined
·
4,684 Posts
My situation is a little more complicated than that since I have a switch that allows me to turn on the camera whenever I want. In my case I have separate 12V and ground for the camera and then the reverse light wire which goes 12V when in reverse. However you could use the reverse light power and ground to power the camera as well. I wouldn’t do it that way but you could do it that way.
 
1 - 4 of 4 Posts
Top