Jeep Wrangler Forum banner
  • Hey everyone! Enter your ride HERE to be a part of JUNE's Ride of the Month Challenge!

1 - 7 of 7 Posts

·
Registered
Joined
·
174 Posts
Discussion Starter · #1 ·
I have put on a couple lifts before but for some reason this is just a pain. I had this bb kit laying around for a while. I decided to put it on today. There were four bump stop spacers. Two long and two about 1/2" shorter. I assumed the long ones went in the front. Well I finally got the front done and I only have about 3/4" clearance for my bumpstops. Before I take it all back apart does anyone know if the long spacers should go in front or in back?
 

·
Registered
Joined
·
8,952 Posts
long ones are for the rear. short ones go on the front.

just throw the jounce, cup and bumpstop extension inside the spring, install the spring and fish the parts up into place by hand. saves a lot of headache vs trying to get the spring in with all that crap in place.
 

·
Registered
Joined
·
174 Posts
Discussion Starter · #4 ·
Ok got the short ones up front. Looks correct now. Will do the back tomorrow. Anything I should know?
 

·
Registered
Joined
·
16,932 Posts
Mine were both same length and mine was level. Ran it for 2 years no worries.. The back is easier if you jack it up and let your axle drop by centering your jack
 
1 - 7 of 7 Posts
Top