Jeep Wrangler Forum banner
1 - 1 of 14 Posts

· Registered
959 Posts
^ Don't listen to them. I would go 53's. That would look awesome! :D

Like they said, your gearing doesn't favor anything larger. You'll need C's for sure and should also do sleeves or truss. Might as well do some ball joints while you're in there too.

On the plus side, you have enough lift to fit them, I run 37s on 3" of lift. MMC runs them on 2.5". So if you're willing to re-gear and weld on your axle then go for it!

Edit: 53's

Whoa Trigger!! What psi on those do you air down to, 200? Lol!

Sent from my iPad using Tapatalk
1 - 1 of 14 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.