Jeep Wrangler Forum banner
  • Hey everyone! Enter your ride HERE to be a part of JUNE's Ride of the Month Challenge!

1 - 5 of 5 Posts

·
Registered
Joined
·
527 Posts
Discussion Starter · #1 ·
So the other day I replaced my blower motor resistor because my fan would only blow on high. At first when I replaced it it didn't work. I unplugged the resistor and replugged it and it began to work. Now today it stopped working again. Is there something I can check? How do I know if the wiring is bad?
 

·
Registered
Joined
·
2,972 Posts
Melted plug/wire at the resistor pack. I had to replace the connector on mine and 5 inches of wire. I bought a generic molex connector and jerry rigged it.
 

·
Registered
Joined
·
284 Posts
A worn out blower motor will draw excess current and melt the wires/plug/make the resistor go bad. You may need a new blower motor, there are threads on how to do it.
 

·
Registered
Joined
·
527 Posts
Discussion Starter · #4 ·
Where's the resistor pack? And it there a way to tell that the blower motor is pulling too much before I buy a new one?
 
1 - 5 of 5 Posts
Top