Jeep Wrangler Forum banner

1 - 7 of 7 Posts

·
Registered
Joined
·
1,344 Posts
Discussion Starter #1
alright, so i was ready to put my headers(new) and intake(milled out) back onto my jeep this evening when i ran across a problem. the bolt on the front of the block has sheared off. need the best way to get that bad boy out. thanks guys.
 

·
Administrator
Joined
·
12,602 Posts
Only thing I have heard of is a and ez-out, which I hear may not be so easy to use.
 

·
I got nothin'
Joined
·
1,901 Posts
4Jeepn said:
Only thing I have heard of is a and ez-out, which I hear may not be so easy to use.
What he^^^^ said. Other than that, you will have to drill it out/have it drilled out and then retap it. Sorry, that always sux when that happens!:mad:
 

·
Jack Lives Here!!!
Joined
·
7,760 Posts
Yup I third that motion. drill it and use and easy out.
 

·
Registered
Joined
·
11 Posts
Those guys are right, but there are different kinds of EZ outs. Some are square and some are fluted. The fluted are my favorite. What ever you do don't break the EZ out, you can't drill one to save your life!!

Steve
 

·
Registered
Joined
·
73 Posts
I've not done this, just speculating, but could another bolt be welded on? Perhaps a smaller diameter bolt so you could run a bead around it onto the busted bolt... then just put a wrench to it and back the whole thing out.
 
1 - 7 of 7 Posts
Top