Jeep Wrangler Forum banner
  • Hey everyone! Enter your ride HERE to be a part of September's Ride of the Month Challenge!
  • Truck seat covers are up to 76% off right now on eBay. Click here for Black! Tan! Multi-coloured! even Camo!
1 - 2 of 2 Posts

·
Registered
1992 4.0l/AX15 & 1988 4.2l/TF999 (Jasper replacement 258 no ECM)
Joined
·
100 Posts
Discussion Starter · #1 ·
Hi--I just got my 1st Jeep yesterday (a 93), and the brakes work fine, but when I let off the pedal, it doesn't come all the way back to where it started.

Because of this, my brake lights stay on unless I pull the pedal all the way back up (only about 1/4 - 1/2 inch).

I looked under the dash, but could see no place to adjust it.

Any ideas?

Thanks.
 

·
Registered
1992 4.0l/AX15 & 1988 4.2l/TF999 (Jasper replacement 258 no ECM)
Joined
·
100 Posts
Discussion Starter · #2 ·
Never mind--I figured it out. (The brake light switch was seated too far in it's hole, hindering the pedal from returning all the way.)
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top