Jeep Wrangler Forum banner
  • Hey everyone! Enter your ride HERE to be a part of JUNE's Ride of the Month Challenge!

1 - 2 of 2 Posts

·
Registered
Joined
·
4 Posts
Discussion Starter · #1 ·
To make a long story short when I went to install my 4.5" long arm kit I came to find out that previous owner had cut the bump stop cups in the front/rear in half. I was wondering if anyone had any info on where I could purchases these cups, and any advice on removal? At this point it appears a torch, time, and some channel locks are going to be my solution on removal.

Just trying to get bump stops back in there with the RE bump stop bottom extensions to keep my Blistein 5100s from blowing out. Thanks for any tips or leads!
 
1 - 2 of 2 Posts
Top