Jeep Wrangler Forum banner
  • Hey everyone! Enter your ride HERE to be a part of September's Ride of the Month Challenge!
1 - 2 of 2 Posts

·
Registered
Joined
·
1,221 Posts
Discussion Starter · #1 ·
I might have the chance to grab a Millermatic 180 MIG for for roughly $600 from a pawn shop. They said they tested it and it works but I'm not sure if I'll be able to test it in person when I buy it, likely an "as is sale."

Even if it doesn't work I'm still $400 ahead of a new one. Would anyone recommend against picking this up? I know replacement parts are quite common for this welder so I could easily fix anything that is broken. Is there anything I should look for if I can't power it up in person?
 
1 - 2 of 2 Posts
Top