Jeep Wrangler Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
3 Posts
Discussion Starter #1
Hey everybody, I recently finished installing a CB radio in my jeep and I have been having interference problems. I believe it may be the cable I used since it is somewhat cheap, and when i tune the SWR the needle will sometimes drop off the scale when the cable is moved slightly, anyway I am getting better quality cable and redoing the routing job. Right now my cable is run along the top of the windshield and then down along the passenger door then along the carpet out to the tailgate. Since I am redoing the routing I was thinking of putting the cable along the roll bar inside the fabric but not inside the metal. The only places I could see having a problem is where I would have to cut the fabric at the top of where the sound-bar is located. I think it may also save me some cable which would be nice because I barely had enough to do it the first time. Has anyone else tried this?
 

·
Registered
Joined
·
594 Posts
I ran mine there worked real good
 
1 - 3 of 3 Posts
Top