Jeep Wrangler Forum banner

check engine light!!?

533 Views 2 Replies 2 Participants Last post by  Burdine02x
Just got this jeep runs and drives like a champ. But when I put it in 4x4 the engine light comes on and stays on. If I undo battery ect then hook everything back up it's gone until I put it into 4x4. Need help thanks.
1 - 1 of 1 Posts

· Registered
Joined
·
1,416 Posts
You need to read the error code when the light is on.

Most years you can just turn the ignition key On, Off, On, Off, On, don't start it, codes will display in the odo.

Or, you can get Autozone, etc to read the codes.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top