Jeep Wrangler Forum banner
  • Hey everyone! Enter your ride HERE to be a part of September's Ride of the Month Challenge!
1 - 5 of 5 Posts

·
Registered
Joined
·
901 Posts
Discussion Starter · #1 ·
Ok, I had a new clutch and clutch hydro cylinder put in. I keep on losing the freeplay in the clutch and it grabs right off the floor. I take the cap of the hydro system and pump it a few times and it does improve but after a while I lose it again. Is there air in the system? If so how can I bleed it out?:confused: Any help is greatly appreciated.
 

·
Registered
Joined
·
19 Posts
If it is an external slave not sure what you are working on ,I removed mine and pumped it by hand. Quadratec has instructions on there tech page.
 
1 - 5 of 5 Posts
Top