Jeep Wrangler Forum banner
1 - 2 of 2 Posts

· Registered
32 Posts
Discussion Starter · #1 ·
Has anyone replaced the vacuum assembly? I've read a lot of threads (and the sticky) about replacing the entire set up with a Posi-lock, but that wasn't in the budget. Chilton's doesn't give a real good explanation, so I was wondering if anyone who has replaced could provide some advice...

1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.