Jeep Wrangler Forum banner
  • Hey everyone! Enter your ride HERE to be a part of Aug's Ride of the Month Challenge!
1 - 2 of 2 Posts

·
Registered
Joined
·
153 Posts
Discussion Starter · #1 ·
I was wondering if anyone make a weld on truss kit for the fron dana 30? one that uses a piece of DOM tubing to connect the knuckles to the diff housing and some plate to fill in the open area. I would also be intested in the same set up for the rear dana 35 also.
 

·
Retired Moderator
Joined
·
7,757 Posts
I have seen them around. I think I even saw one on Ebay not too long ago.
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top