Jeep Wrangler Forum banner
  • Hey everyone! Enter your ride HERE to be a part of JUNE's Ride of the Month Challenge!

1 - 2 of 2 Posts

·
Registered
Joined
·
453 Posts
Discussion Starter · #1 ·
I am trying to do a diy dome light kill switch just like the one that quadratec sells so that i no longer have to pull the fuse when my doors are off. I purchased a dome light switch from OTRATTW to match the rest of my switches. My switches all have 2 LEDs (one dependent, one independent). I have wired it like the schematic i drew here. In this wiring, the dome light does flick on and off with the switch but the led's are not working in the correct orientation. Any suggestions?
 

·
Registered
Joined
·
3,042 Posts
i would say to just run a switch between the fuse block(#4 and the lights)
 
1 - 2 of 2 Posts
Top