Jeep Wrangler Forum banner
  • Hey everyone! Enter your ride HERE to be a part of JUNE's Ride of the Month Challenge!

1 - 3 of 3 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter · #1 ·
These are some pics of the door pegs that I fabricated to avoid paying an arm and leg. Peg is 1" schedule 80 black iron cut to 5 1/2" I used schd 80 to have a nice platform to weld to but schd 40 would be fine, end plate is 1/4" diamond plate steel cut to match pipe curve,mounting plate is 1 1/2"x1 1/2" 1/4" plate steel, bolt mount is 1/2"x1/2" plate steel, 1- 3/8"x3" hex head bolt, 1/2" aluminum bushing, nylon washers to protect door hinges on top and bottom and bump stop is 1/4"x1" hex head with nut to stop rubber washer.
 

Attachments

1 - 3 of 3 Posts
Top