Jeep Wrangler Forum banner
1 - 3 of 3 Posts

·
Fields of pain is where I graze
Joined
·
3,324 Posts
Discussion Starter · #1 ·
recently herculined my vehicle and was going to leave my drain plugs out since i'm only using a safari top right now. i noticed that the floor boards have two layers with a space in between. i know the top of the floor boards will be fine, but was wondering about water going through the plug and just resting on the bottom layer. was thinking about a rubber tube or something that would direct the water right through the jeep. has anyone done this or do i just have to much time on my hands?
 

·
Registered
Joined
·
2,748 Posts
The plugs should be just holes everywhere except the passenger rear footwell plug. If I am not mistaken, thats the heatshield for the cat/muffler. I would leave it alone. It drains a little slower than just a hole, but it certainly wont just pool up there, it does drain.

my .02
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top