Jeep Wrangler Forum banner

1 - 1 of 1 Posts

·
Registered
Joined
·
130 Posts
Discussion Starter #1
So I bought a duster/tonneau cover from FN Jeep in Colorado springs. The guys there are right almost all the time, however this cover I got doesn't seem to fit.

1: It seems like it's too short from side to side.

2. The plastic pieces that go into my soft top channels are longer than the channels are deep


Both my soft top and this duster are made by Bestop. My dad and I are thinking it might just be tight since it's been sitting in a warehouse and then our garage for a while and I currently have it in the sun.

I am looking for a couple things tip wise:

1: Measurements of a YJ family bar style tonneau/duster.
2: Easy steps to installing if I got the correct one.

Any and all help would be fantastic.
 
1 - 1 of 1 Posts
Top