Jeep Wrangler Forum banner

1 - 1 of 1 Posts

·
Registered
Joined
·
7 Posts
Discussion Starter #1
Friends,

I just recently added the Rugged Ridge Modular High Mount Snorkel Kit to my Wrangler, and I love it! However, I noticed that when I remote start my Jeep it will trigger engine code PO113.

P0113, “Intake Air Temperature Sensor 1 Circuit High”

Does anyone have any ideas where I might begin with this? The engine light is only triggered when I use the remote start. If I drive around for a while the engine light will disappear until I attempt to use the remote start again. The engine light triggering during the remote start also aborts the remote start, so I can’t use my remote start this winter until I solve P0113.

Any help would be much appreciated.
 
1 - 1 of 1 Posts
Top