Jeep Wrangler Forum banner
1 - 2 of 2 Posts

· Registered
117 Posts
Discussion Starter · #1 ·
I have a 98 Tj 2.4l
I am experiencing a small engine studder in all gears during acceleration at the 3000 rpm mark.

The motor has a new radiator, head, head gasket. I just had a new muffler and cat welded in place too. The head work was done 3 months ago by the previous owner.

Plugs, wires and distributor cap look new'ish but the previous owner didn't say that they were and I didn't ask.

Any thoughts or things I should look for?

Thanks, DS
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.