Jeep Wrangler Forum banner
  • Hey everyone! Enter your ride HERE to be a part of Aug's Ride of the Month Challenge!
1 - 1 of 1 Posts

102 Posts
Discussion Starter · #1 ·
Got these suckers in and I'm going to install a 2" PSC reverse Light in it. Therefore I need to drill holes for the flush mount lights. Any suggestions on where to drill them in correlation to the brake light? Wish the brake light was drilled higher as the PSC's are but I couldn't justify double the price for the PSC corners.

Also, not a fan of painting aluminum. Anyone thing bare aluminum would look stupid on a black jeep?
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.