Jeep Wrangler Forum banner
  • Hey everyone! Enter your ride HERE to be a part of January's Ride of the Month Challenge!
1 - 1 of 1 Posts

·
Registered
Joined
·
1,104 Posts
I discovered a stupid mistake I made while installing my turbo. I pushed the exhaust extension pipe too deep into the stock cat-back exhaust pipe. The whole stock cat-back system was pulled forward when I tightened the extension pipe to the down pipe, which caused this to happen: The hump in the exhaust over the rear axle is out of alignment now, and the rear track bar crushed the exhaust a bit when my suspension bottomed out at some point (probably that day I spent off road soon after the install). I wonder how much power I'm losing because of this exhaust constriction. Anybody have ideas for the cheapest way to fix this? I've already posted in the "wanted" section of a few forums for stock exhaust take-offs.
I could be wrong...but I think they come that way stock. Mine brand new had the same bend in it just over the axle prior to doing any off-roading...again, I could be wrong.
 
1 - 1 of 1 Posts
Top