Jeep Wrangler Forum banner
  • Hey everyone! Enter your ride HERE to be a part of September's Ride of the Month Challenge!
1 - 1 of 1 Posts

·
Registered
Joined
·
21 Posts
Discussion Starter · #1 ·
I AM ABOUT TO CHANGE MY LEAKING SLAVE CYLINDER AND CLUTCH. THE SLAVE CYLINDER IS AN INTERNAL. I HAVE HEARD SOME SAY THAT IT MIGHT BE SMART TO SWAP THE BELLHOUSING TO AN EXTERNAL SETUP. SO THE NEXT TIME THE SLAVE GOES BAD, I DON'T NEED TO DROP THE TRANNY. HOW WOULD THIS BE ACHIEVED? DO I NEED TO GET A DIFFERENT BELLHOUSING? HOW DIFFICULT OF A JOB WOULD THIS BE? I WOULD APPRECIATE ANY FEEDBACK. THANK YOU!
 
1 - 1 of 1 Posts
Top