Jeep Wrangler Forum banner
  • Hey everyone! Enter your ride HERE to be a part of September's Ride of the Month Challenge!
1 - 2 of 2 Posts

·
Registered
Joined
·
239 Posts
Discussion Starter · #1 ·
I'm going to install some better reverse lights today and was planning on splicing into the factory hitch wire harness - anybody have a diagram or tips/tricks? Thanks!!

:punk:
 

·
Registered
Joined
·
3,939 Posts
if you are talking about tying into your trailer light pigtail then unless yours is different than any I have every had it does not have a back up light hotwire..if I didn't have a wiring diagram I would probably remove a tail light lens and see what color wire went to the back up light and then follow that wire loom back to a good place to tie in and then verify that that wire got voltage when your factory back up lights came on
 
1 - 2 of 2 Posts
Top