Jeep Wrangler Forum banner
  • Hey everyone! Enter your ride HERE to be a part of JUNE's Ride of the Month Challenge!

1 - 1 of 1 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter · #1 ·
a couple months ago I installed a new clutch kit ( clutch, pressure plate, throw out bearing, pilot bearing) and a new master/slave cylinder prefilled combo. everything was working fine. go to move the jeep and I cant go into gear. itll go into gear with engine off but not while running. check the hydraulics- its full no signs of leak. removed the slave cylinder- it working. any ideas? 97 tj 4.0L with ax15
 
1 - 1 of 1 Posts
Top