Jeep Wrangler Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
541 Posts
Discussion Starter #1
Putting on some aftermarket flares tomorrow that were given to me. So I don't have any hardware. Will the screws holding on the factory ones be sufficient to hold on the aftermarket ones? Or do you guys think I should just use some bigger self screws?
 

·
Premium Member
Joined
·
10,093 Posts
I would try what is on there fiirst. IMHO
 

·
Registered
Joined
·
187 Posts
They should work fine if they are salvagable. How ever mine were not so I over did it. I just used 1/4" ss bolts, flat washer, locker washer, and nuts. It took a little longer but I know they will be there for the long run now
 
1 - 3 of 3 Posts
Top