Jeep Wrangler Forum banner

1 - 5 of 5 Posts

·
Registered
Joined
·
150 Posts
Discussion Starter #1
Hey all, I recently completed my first lift, but was hurried and sick when doing so and despite attempting to triple-check everything, I managed to flub up one of the most obvious aspects - I didn't seat the front coils correctly. I am going back into the shop early next week (as soon as I can) in order to correct this, but am wondering if I will cause any damage to the coils/Jeep in the meantime by driving it as is...any experience/advice/comments?

coil worry.jpg


Thanks, - Mat
 

·
Registered
Joined
·
722 Posts
I screwed up too my first time. Didn't get the coil ends in the grooves.

Don't worry. You're not going to hurt anything. Get them fixed and enjoy your lift.
 

·
Registered
Joined
·
150 Posts
Discussion Starter #3
Thanks, xzy...I'm diggin' that front-end set-up you have going on...don't think I've seen anything quite like that before...
 
1 - 5 of 5 Posts
Top