Jeep Wrangler Forum banner

1 - 5 of 5 Posts

·
Registered
Joined
·
5,130 Posts
Discussion Starter #1
Currently in the process of ordering a G2 Core44 Front axle assembly with 5.38s and TruTrac .. The set up comes with Placer Gold Axles however I would rather have them swapped for RCV axles.. Price is very close between the 2.

What are the pros and cons of both?

2008 4dr, 4" lift .. 80% on road DD with 37" PitBulls - 20% offroad consists of snow and ice in the winter, mud, water crossings bush and rock in the summer..

Thanks in advance ..
 

·
Registered
Joined
·
511 Posts
im guessing the G2 axle shafts are just chromo with a spicer joint. RCV's are RCV's. If the price was the same I would be in RCV's with out hesitation.
 

·
Registered
Joined
·
5,130 Posts
Discussion Starter #5
im guessing the G2 axle shafts are just chromo with a spicer joint. RCV's are RCV's. If the price was the same I would be in RCV's with out hesitation.
Yes spicer 1350 UJoints with full circle clips. About $200 difference for the set..
 
1 - 5 of 5 Posts
Top