Jeep Wrangler Forum banner

Having trouble securing the sensor on the intake tube

699 Views 6 Replies 4 Participants Last post by  A5150nut
I see the sensor plug has special fittings to line up with the intake tube receptor. I tried lining them up and turning it in the direction the arrow indicates but it's not locking in place.

I think the sensor plug is supposed to go flush first and then you rotate it.

Any idea what i'm doing wrong?

Tire Automotive tire Wheel Motor vehicle Tread

White Automotive tire Gear Gas Rim

Automotive tire Motor vehicle Automotive fuel system Bumper Automotive exterior
1 - 7 of 7 Posts

· Registered
2012 Wrangler JK lifted rockcrawlers and 33s.
Joined
·
231 Posts
Discussion Starter · #6 ·
One wing is bigger than the other. Even with the wings lined up the sensor wouldn't go in. I finally resorted to some spit and it went in.

I've taken this off in the past and put it back on. It was never this tough.

Thanks for the help guys.
 
1 - 7 of 7 Posts
Top