Jeep Wrangler Forum banner

Headlight switch removal

13831 Views 3 Replies 4 Participants Last post by  DuneRider
I have a 1997 wrangler and recently been having problems with the headlights turning on. When I pull the switch I have to fiddle with the pull out knob to get where they stay on. I figure it may be the headlight switch assembly? I am at the point where i unplugged the 2 wiring harness to the switch. How do I remove the switch and pull out knob? I dont see any screws holding it in place. any help would be appreciated. thanks
1 - 1 of 1 Posts

· Knows a couple things...
2004 Wrangler TJ with 42RLE auto trans. F/R lockers, 5.38 gears, Warn Winch, Currie 4" Suspension
Joined
·
50,052 Posts
The switch is held in place by two screws on the front of the dash underneath the lower plastic panel that the switch protrudes through. Remove the two screws that hold the lower plastic panel on and then pull it over the headlight knob, the panel hinges from the bottom.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top