Jeep Wrangler Forum banner

Heater Blower Fan Plwase Help

701 2
So today I removed the fan and put in the new one. But before I put it in i tested it and I showed contintinuty between the two wires. Now I know there should not be, but not sure on this. Testeded with a batt. and it ran. I put it in and it ran good for about 30 min then it melted the wire and no more heater fan. Does any one have any ideas?:banghead:
1 - 2 of 2 Posts
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top