Jeep Wrangler Forum banner
  • Hey everyone! Enter your ride HERE to be a part of Aug's Ride of the Month Challenge!
1 - 5 of 5 Posts

·
Registered
2006 Jeep Wrangler LJ Rubicon
Joined
·
152 Posts
Discussion Starter · #1 ·
My heater mode select is acting up. It was not changing vent position and I did not find a vacuum link so I replaced the selector switch. Now it is changing the vent control like it should with one caveat. No matter the selection some air will always blow from the face level vents. What does this mean??????

Thanks, Wade
 

·
Registered
2006 Jeep Wrangler LJ Rubicon
Joined
·
152 Posts
Discussion Starter · #3 ·
Thanks. Where are those located?

Wade
 

·
Registered
2006 Jeep Wrangler LJ Rubicon
Joined
·
152 Posts
Discussion Starter · #5 ·
I need more help. I found the actuators under the dash off to the left of the console (right of drivers floor). The two actuators are moving when I use the selector but I still have dash air on all the time. Am I overlooking a third actuator or is there something else I'm missing?
 
1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top