Jeep Wrangler Forum banner

1 - 2 of 2 Posts

·
Registered
Joined
·
4 Posts
Discussion Starter #1 (Edited by Moderator)
I have an AMC 20 axle and obviously the axle shafts suck in them so I heard a lot of people are putting Dana 60 axle shafts in them are there any problems I will run into if I do that, and are the number of teeth on the splines the same?
 

·
Administrator
Joined
·
12,487 Posts
You can't put dana 60 shafts in a model 20.. Just upgrade the stock shafts to 1pc after market and your good for 35's.
 
1 - 2 of 2 Posts
Top