Jeep Wrangler Forum banner

1 - 4 of 4 Posts

·
Registered
Joined
·
38 Posts
Discussion Starter #1
So I bought a Master Rebuild kit from G2 35-2049 which is all the bearings, shims and etc. Well I opened the box to find circular bearings and not coned shaped bearings. The guys from 4wd.com told me that its for a dana 35 complete kit. I don't know if its going to fit.
 

·
Registered
Joined
·
2,925 Posts
Not trying to be sarcastic here at all...

Did you unpack them and separate the races from the bearings? A lot of times the races and bearings are combined and packaged, making it look like what you are describing.


This is a tapered bearing sitting with its race....



separate it...



the only roller bearings in the D35 are the axle bearings, everything else is tapered bearings with races.
 

·
Registered
Joined
·
304 Posts
DirtyD937 said:
Yeah. I spoke before I opened it up. Now what would this Race go on?
The bearing and race shown is for the carrier. The bearing is pressed onto the carrier and then you put the race over it before you place it in the diff with the shims on both sides. Also the pinion is a tapered bearing but the race is installed in the diff instead of sliding over the bearing.
 
1 - 4 of 4 Posts
Top