Jeep Wrangler Forum banner
1 - 1 of 1 Posts

801 Posts
Discussion Starter · #1 ·
Issue with OR-FAB Vacuum pump relocation bracket

I chose to use the OR-FAB relocation bracket over others because it moved the vacuum pump completely away from the bumper area up into the engine compartment. That seemed like a better option than leaving it down there.

However after installing it last night the bracket places it where it lightly touches a plastic mount in the engine compartment. The pump vibrates when it operates It is on rubber isolation mounts but now it vibrates against the plastic. I've rechecked the instructions and watched a video. It's mounted properly according to those. Has anyone else had this issue? It needs to be about a half inch further inboard.
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.