Jeep Wrangler Forum banner
1 - 1 of 1 Posts

·
Premium Member
Joined
·
1,965 Posts
Notes:
You need to completely unmount the plastic tray that holds the ABS unit and ECU in order to make enough space to fit the master into the brake booster. This is not mentioned in the install instructions
This is not mentioned because it's not necessary. If you simply slip both the booster and then the master loosely into place before installing any of the nuts everything falls right in. Then you can put the nuts on both and tighten everything up. Yes, it is close quarters but nowhere as difficult as some might let on. I've done this a number of times, a couple of which for guys that couldn't figure it out, and never had an issue. The only thing I do to make things easier is to remove the inner fender to allow access through the wheel well to a couple of the nuts.
 
1 - 1 of 1 Posts
Top