Jeep Wrangler Forum banner
1 - 1 of 1 Posts

· Registered
Joined
·
4,757 Posts
Its possible that the shift linkage for the t-case isnt adjusted properly. Even if the lever inside says its in 2wd it might be in neutral.

If you crawl under it and look at the linkage, the last rod back(where it hooks to the t-case), should be back as far as it can go to be in 2wd.

That would be my only guess, unless the clutch is out of it completely.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top