Jeep Wrangler Forum banner
  • Hey everyone! Enter your ride HERE to be a part of JUNE's Ride of the Month Challenge!

1 - 5 of 5 Posts

·
Registered
Joined
·
265 Posts
p0320 is a crankshaft position sensor circuit failure.

The sensor is located on the driver's side of your bellhousing. Without this working properly, the ecm will not allow the jeep to start.
 

·
Commercial Member
Joined
·
5,792 Posts
p0320 is a crankshaft position sensor circuit failure.

The sensor is located on the driver's side of your bellhousing. Without this working properly, the ecm will not allow the jeep to start.
^^^ this x2
 

·
Registered
Joined
·
12 Posts
Discussion Starter · #4 ·
Thanks just replaced it about an hour ago. The jeep is now RUNNING !!! Replacing the sensor wasn't bad, but getting plugged in was not fun. Thanks again for the help.
 

·
Registered
Joined
·
265 Posts
Glad you got it sorted out :thumb:
 
1 - 5 of 5 Posts
Top