Jeep Wrangler Forum banner

1 - 7 of 7 Posts

·
Jeeper
Joined
·
722 Posts
Discussion Starter #1
Back on November 30th we picked up a 2015 Jeep Wrangler JKU Sport to use for designing JK products. We're going to build it with the intent to showcase bumpers, sliders, and other misc. products. If there's any questions along the way, feel free to ask!

Starting to collect parts and also install some along the way:

Stock:




Picked up a Warn Zeon 10s winch and a Factor55 ProLink for the bumper we're working on.



Then, picked up some Vision X fog light replacements:




Then, picked up more stuff: ARB Old Man Emu 4" lift. Sold the OME shocks and picked up Bilsteins. ARB black differential covers. Got some Daystar stuff too: hood wranglers, couple of switches, and the lower dash switch panel. Not sure if Im going to put the Rigid Dually's on this Jeep or the TJ.



The VisionX LED headlights came in and I put them in:




 

·
Jeeper
Joined
·
722 Posts
Discussion Starter #2
Finished designing our JK lower A-pillar light brackets, and installed a pair along with some Rigid D2 Hyper Spots;

 

·
Jeeper
Joined
·
722 Posts
Discussion Starter #6
Jeep was at the dealer for a while, getting a few things fixed and a door repainted. Finally got it back so we can get on with adding parts.

sPOD install started. Got the switch panel and wires run out into the engine compartment with the actual sPOD power block mounted. Need to wire it to the battery and start adding accessories.

 
1 - 7 of 7 Posts
Top