Jeep Wrangler Forum banner
1 - 5 of 5 Posts

· Registered
320 Posts
Discussion Starter · #1 ·
I recently put in a pair of 4" round led tailights after which i discovered that leds take less amps to run so when i turn on the turn signal it flashes super fast which brings me to my question I need to install resisters but i dont know what size? to use. also do you wire them inline on just the stop/turn wire or stop/turn wire to ground wire like a lightbulb works?

save me from the fierce flasher!
thanks x2
1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.