Jeep Wrangler Forum banner
  • Hey everyone! Enter your ride HERE to be a part of September's Ride of the Month Challenge!
1 - 3 of 3 Posts

·
Registered
Joined
·
67 Posts
Discussion Starter · #1 ·
My shifter boot kept sliding down into my console so I figured it was because the boot bezel was missing. I bought one and installed it but can't quite figure out how it helps matters.

Of course I got it to snap into place but it doesnt seem to hold the boot, am I missing something?

Thanks
 

Attachments

·
Registered
Joined
·
2,362 Posts
Boot goes over the outside of the bezel, then bezel goes clipped into console. Just did it the other night on mine.
 
1 - 3 of 3 Posts
Top