Jeep Wrangler Forum banner

1 - 8 of 8 Posts

·
Registered
Joined
·
197 Posts
Discussion Starter #1
I Don't have a solid table for a vise that won't move around while working on it. I put this together at work out of scrap tube. Now I have a vise that won't move around on me ( unless some one moves the jeep ).
 

Attachments

·
Supporting Member
Joined
·
2,837 Posts
I Don't have a solid table for a vise that won't move around while working on it. I put this together at work out of scrap tube. Now I have a vise that won't move around on me ( unless some one moves the jeep ).
It's a great idea but it won't work well for where I wheel. Too many ledges. For it to hang up on
 

·
Registered
Joined
·
197 Posts
Discussion Starter #3
It will pull out just like a trailer hitch.
 

·
Registered
Joined
·
197 Posts
Discussion Starter #7
It's actually a little to tall. I was thinking about shortening it and make it foldable.
 

·
Registered
Joined
·
4,757 Posts
Its a great idea and all that, but unless you have a receiver inside the jeep somewhere to mount it when not in use, I would hate to have that 50lb vise come thru the air at me if I happen to roll over. That would really ruin your day, or life, depending on who and how hard it hit.
 
1 - 8 of 8 Posts
Top