Jeep Wrangler Forum banner
  • Hey everyone! Enter your ride HERE to be a part of JUNE's Ride of the Month Challenge!

1 - 2 of 2 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter · #1 ·
I purchased this factory wiring kit, 7 pin type and the instructions have you pull part of the wiring into the vehicle through the fire wall into the driver's foot well. It doesn't get connected to anything, only wire tied underneath. It's step #17 on the directions. Why would they have you go through the trouble to pull this wire inside and not terminate to anything. Any input would be appreciated.
 
1 - 2 of 2 Posts
Top