Jeep Wrangler Forum banner

1 - 2 of 2 Posts

·
Registered
Joined
·
85 Posts
Discussion Starter #1
Been looking everywhere for a pic of what the hub end of a 35 spline RCV rear shaft looks like mounted.
Say a guy found a good deal on a built rear axle. What indication do I have that there are in fact RCV’s in it?
The axle I’m looking at doesn’t have a sticker logo like Ten Factory, nitro, Yukon etc on the ends where the hub is. Just metal.
Also, are 32 or 35 spline the same in this regard?
Thanks!
 
1 - 2 of 2 Posts
Top