Jeep Wrangler Forum banner
  • Hey everyone! Enter your ride HERE to be a part of JUNE's Ride of the Month Challenge!

1 - 4 of 4 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter · #1 ·
Ok guys, I'm new to asking questions. But I've gotten great info here. I've got a 2010 JKU Rubicon, 73,000. Got a 2.5 inch lift running 35s.

I had what I thought was angry sparrows. I drove around for a few days without front driveshaft, and still had the sound. So today I replaced both CV joint in rear driveshaft.

And it's STILL chirping only when I accelerate from a complete stop. It happens after I've been driving for a bit. Any ideas?
 

·
Premium Member
Joined
·
3,104 Posts
Ok guys, I'm new to asking questions. But I've gotten great info here. I've got a 2010 JKU Rubicon, 73,000. Got a 2.5 inch lift running 35s.

I had what I thought was angry sparrows. I drove around for a few days without front driveshaft, and still had the sound. So today I replaced both CV joint in rear driveshaft.

And it's STILL chirping only when I accelerate from a complete stop. It happens after I've been driving for a bit. Any ideas?
Could be axle shaft u-joints, since you have eliminated the other (driveshaft) joints.


-Steven
 
1 - 4 of 4 Posts
Top