Jeep Wrangler Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
330 Posts
Discussion Starter · #1 ·
Good morning, all. I realize I'm going about this in a less-than-ideal way, but I'm up against a time crunch. I'm currently building a 2016 JK (in signature) and will be installing a Metalcloak 3.5" gamechanger lift as well as a new Teraflex Tera44 front axle housing. I'll need a new driveshaft, due to the lift height and the differences between the original Rubicon Dana 44 and the Tera44.

My question: Does anyone have a similar setup as mine.....3-4" lift and Tera44 that can share their driveshaft measurements? I'm wanting to go ahead and order my driveshaft now, so I can have it by the time all my parts arrive.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top